Reference
Ship tracking glossary
The 40 terms you will meet on the map, on vessel and port pages and in the API, each in a couple of sentences. Every entry has its own address, so you can link straight to a definition. The guides go into the detail.
Last reviewed
A
- AISAutomatic Identification System
- A VHF radio system in which ships automatically broadcast who they are, where they are and how they are moving, and receive the same from ships around them. It was designed for collision avoidance and for coastal authorities; ship-tracking websites exist because the broadcasts are unencrypted and anyone with a receiver in range can pick them up. How AIS ship tracking works →
- AIS-SARTAIS search and rescue transmitter
- A locating beacon carried in survival craft. When activated it transmits its position over AIS with navigational status 14 so that nearby ships can home in on it. Its identity starts with 970; man-overboard devices use 972 and AIS-equipped emergency beacons 974. MMSI numbers and country codes (MID) →
- Alert areageofence
- A rectangle you draw on the VesselTrack map. An alert is raised when a vessel crosses into it, out of it, or both — either for vessels in your fleet only, or for every vessel of the ship types you choose. Part of Pro. Alerts, alert areas and webhooks →
- At anchor
- Navigational status 1: the ship is held by her anchor. Along with “moored” it is one of the two statuses VesselTrack treats as stopped, and it draws the vessel as a dot rather than an arrow. AIS navigation status codes →
B
- Beam
- The width of a ship at her widest point. AIS does not send it directly: the transponder is programmed with four distances from its antenna to the bow, stern, port side and starboard side, and the beam shown on a vessel page is the two sideways distances added together.
C
- Call sign
- The identifier of a ship’s radio station, issued by the authority that licenses it — a short mix of letters and digits. AIS carries it in a seven-character field. Like an MMSI it normally changes when the ship changes flag. IMO numbers →
- Class A
- The full-specification AIS transponder that ships covered by the SOLAS convention must carry. It transmits at 12.5 watts, reports its position every 2 to 10 seconds when moving and every 3 minutes at anchor, and sends the ship’s name, type, dimensions, destination and ETA every 6 minutes. VesselTrack currently collects only Class A reports. How AIS ship tracking works →
- Class B
- A cheaper, lower-powered AIS transponder used mostly by yachts, small fishing boats and workboats. It reports less often than Class A, and it does not send a navigational status, destination, ETA, draught or IMO number. VesselTrack does not currently collect Class B reports, so most small craft do not appear on the map. How AIS ship tracking works →
- COGcourse over ground
- The direction a vessel is actually travelling across the Earth’s surface, in degrees clockwise from true north, taken from her satellite-navigation receiver. It differs from the heading whenever wind or current pushes the ship sideways. AIS sends it to a tenth of a degree.
- Constrained by her draught
- Navigational status 4: a power-driven vessel that sits so deep in the water, relative to the depth and width of the channel, that she is severely restricted in her ability to deviate from her course. AIS navigation status codes →
D
- Destination
- A field of up to 20 characters that the crew type into the transponder by hand. There is no enforced format: it may be a port name, a UN/LOCODE, an abbreviation, “FOR ORDERS” or a leftover from the last voyage. VesselTrack shows it as broadcast and, where it can, matches it to a port. Destinations, ETAs and UN/LOCODEs →
- Draughtdraft
- How deep the hull reaches below the waterline, in metres. The AIS value is the “maximum present static draught”, entered by the crew to the nearest 0.1 m, so it is only as current as the last time someone changed it. The field cannot express more than 25.5 m.
E
- ETAestimated time of arrival
- When the crew expect to arrive at the destination they entered. AIS carries it as month, day, hour and minute in UTC — with no year — so VesselTrack infers the year and labels the result as crew-entered. It is a statement of intent, not a prediction calculated by this site. Destinations, ETAs and UN/LOCODEs →
F
- Flagflag state
- The country where a ship is registered. AIS has no flag field: VesselTrack derives the flag from the first three digits of the MMSI (the MID), which identify the administration that issued the number. MMSI numbers and country codes (MID) →
- Fleetwatchlist
- Your own list of vessels on VesselTrack. Vessels in it are ringed on the map and listed with their current position, status and destination; with Pro, each one can have alert rules. Alerts, alert areas and webhooks →
H
- Headingtrue heading
- The direction the bow is pointing, in whole degrees clockwise from true north, taken from the ship’s compass. Moving vessels on the map are drawn as arrows along their heading; if a ship sends no heading (the value 511 means “not available”) the course over ground is used instead. How to read the live map →
I
- IMO number
- A seven-digit number assigned to a ship’s hull under the International Maritime Organization’s identification scheme. It stays with the ship for life, through every change of name, owner and flag, and is never reassigned. The last digit is a check digit. IMO numbers →
K
- Knotkn
- One nautical mile per hour: 1.852 km/h. All speeds on VesselTrack are in knots.
L
- Last-known position
- The most recent position VesselTrack has received for a vessel, shown with its age. A vessel that has sailed out of range of shore receivers stays on the map at its last-known position; its marker fades after an hour and fades further after a day. How to read the live map →
- Lengthlength overall
- The length of the ship from bow to stern in metres. On a vessel page it is the sum of the two fore-and-aft distances the transponder is programmed with (antenna to bow, antenna to stern).
M
- MIDMaritime Identification Digits
- The three digits inside an MMSI that identify the country or territory whose administration issued it, allocated by the International Telecommunication Union. They run from 201 to 775; 512, for example, is New Zealand. MMSI numbers and country codes (MID) →
- MMSIMaritime Mobile Service Identity
- The nine-digit number that identifies a ship’s radio station, and so every AIS message it sends. It is issued by the flag state, begins with that state’s MID, and usually changes when the ship is re-registered under another flag. MMSI numbers and country codes (MID) →
- Moored
- Navigational status 5: made fast to a berth, pier or mooring buoy. VesselTrack’s arrival alert fires when a watched vessel’s status changes to moored or at anchor. AIS navigation status codes →
N
- Nautical milenm
- The unit of distance at sea: exactly 1,852 metres, about 1.15 statute miles.
- Not under command
- Navigational status 2: a vessel that, through some exceptional circumstance such as an engine or steering failure, cannot manoeuvre to keep out of the way of other vessels. AIS navigation status codes →
P
- Port call
- A visit to a port. VesselTrack records an arrival when a vessel is seen stopped close to a port’s position and a departure when it is next seen well clear of it. Calls made while a vessel or the port was out of receiver range, or while the data feed was offline, are missing. Destinations, ETAs and UN/LOCODEs →
- Position report
- The AIS message a ship sends most often: its identity, position, speed and course over ground, heading, rate of turn and navigational status. A moving Class A ship sends one every 2 to 10 seconds. How AIS ship tracking works →
R
- Rate of turnROT
- How fast the ship’s heading is changing, in degrees per minute to port or starboard, from a rate-of-turn indicator on the bridge. A ship with no such sensor connected sends “not available”.
- Restricted manoeuvrability
- Navigational status 3: a vessel whose work — dredging, cable laying, surveying, servicing a buoy, a difficult tow — restricts her ability to manoeuvre and keep out of the way of other vessels. AIS navigation status codes →
S
- Satellite AIS
- AIS messages picked up by satellites instead of shore stations, which is how ships are followed across open ocean. VesselTrack does not use satellite AIS; its positions come from shore receivers only. How AIS ship tracking works →
- Ship type
- A two-digit code from 0 to 99 programmed into the transponder: the first digit gives the broad category (6 passenger, 7 cargo, 8 tanker) and, for those categories, the second digit says whether dangerous or polluting cargo is carried. VesselTrack groups the codes into the colours used on the map. AIS ship types explained →
- SOGspeed over ground
- The vessel’s speed across the Earth’s surface in knots, from her satellite-navigation receiver, sent in steps of 0.1 knot. It is not the speed through the water: a ship stemming a 3-knot current at 12 knots through the water makes 9 knots over the ground.
- Static and voyage data
- The second kind of message a Class A ship sends, once every 6 minutes: name, call sign, IMO number, ship type, dimensions, and the voyage details the crew enter by hand — destination, ETA and draught. Because it arrives far less often than position reports, a newly heard vessel can appear on the map before its name does. How AIS ship tracking works →
T
- Terrestrial AIS
- AIS received by antennas on land. VHF radio travels roughly in a straight line, so a shore station hears ships out to a few tens of nautical miles depending on how high its antenna is. This is the only kind of AIS data VesselTrack uses. How AIS ship tracking works →
- Track
- The line of past positions for one vessel. VesselTrack stores at most one point per vessel every five minutes and keeps them for 30 days; the track is coloured by speed and drawn dashed where there is a gap in reception. How to read the live map →
U
- UN/LOCODEUnited Nations Code for Trade and Transport Locations
- A five-character code for a place used in trade and transport, maintained by the United Nations Economic Commission for Europe: a two-letter country code followed by three characters for the location, as in NLRTM for Rotterdam. VesselTrack port pages are addressed by UN/LOCODE. Destinations, ETAs and UN/LOCODEs →
- Under way
- Not at anchor, not made fast to the shore and not aground. A ship drifting with her engine stopped is still under way. Navigational status 0 is “under way using engine” and 8 is “under way sailing”. AIS navigation status codes →
- UTCCoordinated Universal Time
- The time standard used at sea and throughout AIS. ETAs are broadcast in UTC, and VesselTrack labels the times on tracks and port pages in UTC so that they mean the same thing wherever you are.
W
- Webhook
- An HTTPS address of yours that VesselTrack sends a small signed JSON message to when something happens — an alert on one of your vessels, or a port arrival matching filters you set — so that your own software can react. Part of Pro. Alerts, alert areas and webhooks →
Sources
Statements about AIS and maritime standards on this page were checked against the following. Statements about what VesselTrack does describe the software as it runs today.
- US Coast Guard Navigation Center — Class A AIS position report and static/voyage dataField-by-field contents of AIS messages 1, 2, 3 and 5, reproduced from Recommendation ITU-R M.1371-5: navigational status codes, ship-type codes, “not available” values.
- US Coast Guard Navigation Center — Types of AISClass A, Class B, AIS-SART, base stations and aids to navigation, and how often each reports.
- ITU — Recommendation ITU-R M.585-10 (assignment and use of identities in the maritime mobile service)MMSI formats for ships, group calls, coast stations, SAR aircraft, aids to navigation, craft associated with a parent ship, and the 970/972/974 device prefixes.
- International Maritime Organization — IMO identification number schemesWhat an IMO number is, which ships get one, who assigns it, and that it is never reassigned.
- UNECE — UN/LOCODE (United Nations Code for Trade and Transport Locations)Code structure (two-letter country + three-character location) and the function classifier that marks a location as a port.
Found a mistake? Email support@vesseltrack.net or see how to contact us. Corrections are made on this page and the review date is updated.